Input needed!!!

[ianc]

Just thought i'd post a few pic's of my new project, it's coming along nicely. It's took some time to get to here, and it's still not finished! So if anyone can see any potential problems at this stage, your input will be greatly appriaciated.

Thanks in advance Ian.



50567

50569

50570

50571

[Ian 777]

Looks nicely put together Ian

Your uc is on backwards compared to mine and would the gyro be better mounted with double sided tape as you cant adjust the gain with the strap?

Every thing else looks good to me:):thumbup:

Ian

[ianc]

Looks nicely put together Ian

Your uc is on backwards compared to mine and would the gyro be better mounted with double sided tape as you cant adjust the gain with the strap?

Every thing else looks good to me:):thumbup:

Ian
Thanks for that I was wandering why it looked abit weird its the UC! I'll swap it around.
The strap is holding the Gyro down coz I wanted to put some presure on my new sticky pad.

[DierWolf]

All looks ok to me, only suggestion i have since you have fiber frame is to locate your 2.4 unit a little more to the middle so you have equal antenna sticking out on each side, right now its to one side more.

Other than that i dont see anything out of the ordinary.

[ianc]

All looks ok to me, only suggestion i have since you have fiber frame is to locate your 2.4 unit a little more to the middle so you have equal antenna sticking out on each side, right now its to one side more.

Other than that i dont see anything out of the ordinary.

Firstly thanks for looking. I didn't even think of that, but I've looked at it and there don't seen to be anything to pin it in the middle.
I'll go back to the drawing board maybe have to fabricate some kind of bracket... :arggg:
Thats all part of the fun of it!!!


Thanks again Ian.