rotaryguy
10-06-2005, 10:48 PM
OK, I have seen all the posts about the old shaft driven eolos and tail vibes but this is the new belt driven LI, I have been jerkin around with the tail on and off for over a week and I am losing all patients, severe vibes!!! and its never been flown.
I have balanced the tail blades countless times by themselves and assembled, I have tried a new set of stock eolo plastic blades, the cf ones come in the kit, 2 new output shafts, a new hub, new grip retaining bolts, silicone tubing on the boom supports, the servo control rod, I have tried removing the cf tail fins, the supports, and no I havent been strapping it down to anything..When I remove the tail bladed its smooth as silk up to 100% with no main blades which is setup to run at a HS of 2500-2600.aaahhhhhhhhhhh!!!!!!!!!!!!!!!!
I am so very unhappy with this thing and its never left the ground! I run my two trex's at a headspeed of 3000-3100 and I have gotton pretty good at getting out the vibes but this thing is totally kickin my A**. :arggg:
I'll call Jeremy @ rchover for advise in the morning but I am fresh out of ideas and completely out of patients.
I have balanced the tail blades countless times by themselves and assembled, I have tried a new set of stock eolo plastic blades, the cf ones come in the kit, 2 new output shafts, a new hub, new grip retaining bolts, silicone tubing on the boom supports, the servo control rod, I have tried removing the cf tail fins, the supports, and no I havent been strapping it down to anything..When I remove the tail bladed its smooth as silk up to 100% with no main blades which is setup to run at a HS of 2500-2600.aaahhhhhhhhhhh!!!!!!!!!!!!!!!!
I am so very unhappy with this thing and its never left the ground! I run my two trex's at a headspeed of 3000-3100 and I have gotton pretty good at getting out the vibes but this thing is totally kickin my A**. :arggg:
I'll call Jeremy @ rchover for advise in the morning but I am fresh out of ideas and completely out of patients.