Logo 20 Tail Gyro Losing Control

[HeliCSR]

My logo tail glitches, today 4 times in 5 mins, then it lost complete control with the heli spinning around moving the rudder does not gain control, but if I land the heli the gyro gains control again and I can take off.

I bench tested this with the main and tail blades off move the right stick in circles, no glitch, It looks like its motor and ESC noise, with no blades on the motor pulls less current only happens with the blades on the heli.

My MX-400 flys with no problems at all, but that motor pulls 1/4 the current.

If tail static was the problem, it would happen on the bench, would it not?

[HeliCSR]

I am now going to install the align 100 Amp ESC. I was using the hacker master O heli.
I had a jeti opto ESC in there worked for a while then all of a sudden it just shuts off the motor. Batteries are fine no loss of voltage there.

So I put the Master O Heli in there that took care of that problem. I like the Align ESC
on my MX-400 real nice smooth start up. So I though I would try the 100 Amp Align on the Logo 20 see what happens.

Hope it gets rid of the tail gyro losing control, I have no other glitch in the other servos
everything is ok on that end.