AR6200 LIGHTS, WHAT THEY MEAN???

[invertsick]

Hi guyz,

After binding my radio and AR6200 receiver, I realize that every time I turn on the heli the receiver lights do different actions.

sometimes both go steady, ( BOTH = RX AND SATTELITE)
sometimes both flash
sometimes RX flash and sattelit solid
and sometimes RX solid and sattelite flash.


But nothing goes wrong during and of the above.
What does each of these actions mean.

thank you

serge

[Pinecone]

What it probably means is that you have the latest firmware, and when you are turning them on, occasionally you get a bit of contact bounce so the Rx or sat is indicating a power loss.

I wish Spekturm had built in a 0.5 second delay to allow you to make a mistake when plugging in or turning on, and not read the low voltage event.

[invertsick]

so is it safe to fly when one of the lights is flashing?

serge

[BarracudaHockey]

Yep.

If you leave the transmitter on while you change the battery or whatever, it will read it as a low voltage event and flash. Same if you fumble with the battery connector while hooking it up.