Plastic blades bent

[zeenon]

Folks,

I have a set of plastic blade that came with a kit that have a slight bend in the middle. Is there a simple way to flatten the blade out?

Z

[psindrup]

Folks,

I have a set of plastic blade that came with a kit that have a slight bend in the middle. Is there a simple way to flatten the blade out?

Z

Just bend/shape them with your hands.
They are never exactly straight anyway. :banana

Peter

[Jetleaf]

I would heat it up with hot water and put it under a couple of phone books till it cooled, should flatten it right out.

[Buzzkill]

Strap a 3S in that baby. That'ii straighten them out :thumbup:

[GreenCello]

So the best way to straiten em is to strap on 3s, go full throttle and insert ito boiling water. Got it.

[ICCA]

So the best way to straiten em is to strap on 3s, go full throttle and insert ito boiling water. Got it.

:lolol :lolol If you wern't so far away, I'd come and watch. :YeaBaby:

Dave

[Gr4yb3ard]

No Sir,

The correct order is: Boiling water, 3s, then full throttle.

By the time you dig it out of the ceiling, or the FAA calls, your blades will be straight!

Gr4yb3ard

[Gr4yb3ard]

Seriously,

Boil them in water for a few minutes, then bend straight by hand and press with a heavy book until they cool.

Gr4