noste500
06-21-2008, 01:49 PM
Just finished my build.
The 20mm bolt that locates through the bell crank into the tail clamp arm is too short.
It is 20mm, ( not 18) and it does not reach through to the nyloc thread in the nut.
I have fitted the 1mm brass spacer above the bell crank.Also the spacer between the bearings in the arm looks correct.
Has anyone had a similar issue?
I suppose it means putting a longer bolt in, just wondering if it has happened to any of you guys??
The 20mm bolt that locates through the bell crank into the tail clamp arm is too short.
It is 20mm, ( not 18) and it does not reach through to the nyloc thread in the nut.
I have fitted the 1mm brass spacer above the bell crank.Also the spacer between the bearings in the arm looks correct.
Has anyone had a similar issue?
I suppose it means putting a longer bolt in, just wondering if it has happened to any of you guys??