Complete Align Rotor Head On Logo20

[HeliCSR]

Hi, does anyone know if an Align 600 complete rotor head will fit on a Logo 20?

The most research I can do, short of buying the head and trying to fit it, is both main shafts are 10mm, the Align is 3mm longer, and the bottom bolt hole the Logo is very close to the bottom of the shaft.

The Align bolt hole is up further, looks like 2-3mm. This seems to work out just right.

Has anyone tried this? I know there is nothing wrong with the Logo20
rotor head, I just like that blue bling.

[Wbird]

Careful now, gonna taint your logo with some align stuff, I wouldn't go there, LOL

Sorry I can't help you with your question, but I do know that the logo 600 head will fit on the T-rex 600 but I think that you have to use all the logo links from the swashplate up as well. (now that would also be an upgrade) LOL

Good luck.

[Mercuriell]

Logo ball links are slight bigger (~0.8mm) than Align ones so you'd have to use Align balls throughout. Main problem would be retaining the main gear on the shaft - the Logo uses a circlip to retain it - the T600 a bolt - probably easiest to use a Logo main shaft and then drill a hole near the top to take the T600 rotor head. Can't see why you'd bother though :arggg:

[Dynamic]

I was considering using my t600 kasama head on the logo for my flybarless system. I think I am going to not try and mod up some wackado system though, regardless of how good it looks. Stock is proven and failures suck.