Anyone with 600n v-bar pics ?

[rcmarty]

Looking for some ideas on where to locate electronics.

I'm going to run : 9451's , 9254 , vbar , ar7000 , 2 in 1 reg , hyper50/mp5 , gv1 ,

Any input on where a good place to put the unit ? This has to be the highest $$ to weight ratio i've seen in a bit.
Only near competition i can see is gasoline !!

Martin :)

[tcast305]

rcmarty,

Here are pics I just took.

I used to have my vbar unit on top of my rx, however I moved it to a more secure place, since I've seen rx units get hit and the vbar sticks higher on top.

My setup:

Trex 600n Pro
JR 8717
Align 2in1 reg
Futaba 9256 tail
YS 50 st with Align Pipe
Multigov with Futaba 9451 throttle
Mikado vbar unit with Mikado conversion kit for Trex 600
Radix 600mm blades
AR7000 RX

Thanks.

[rcmarty]

I was thinking along the same lines.
My flybared setup had the ar700 on top , gv on the muffler side , and the 2 in 1 on the other side , lipo on the bottomside of the mount. Room for a carbsmart in front of the gv1.

I want to get the vbar unit protected as it is very expensive. I think on the side should be a decent spot.

Maby once visa recovers i'll get the ar7100g reciever with the built in revlimiter.

Thanks for the pics.

any advice to give a vbar newbie ?

Gonig with 9451's , vbar , 9254 , 2 in 1 , 4131 th , gv1 , mikado conversion , quk swash ,

Martin :)

[Giggen]

Here are my V-bar file for my 600N.
It works perfektly om my machine:)
Test it out and see.

[realestateguru]

Here is a shot of my 600N....I will give praise and thanks to a great steward of the hobby....

Thanks Matt for the countless hours you put into helping me set up this thing!