Tools for the newbee

[thorny196]

I just got my HBFP and all the spare parts I could find (more money then sense) anyway after looking the helicopter over I realize I do not have a good set of small tools (never saw an HBFP or any RC copter in person) so I was wondering if anyone could recommend a good set of small tools Craftsmen, Kobalt or internet. My nephews are coming this weekend so I do not think I will be flying till next week anyway! Anyway so can anyone recommend a good set of micro tools ?

Thanks
Mike

[RotaryBoy]

I use a small set of Kobalt drivers and a small set of Kobalt pliers (8 different variations).

I have an entire tackle box full of spare parts.

Don't forget blade balancing goodies (tape and something to fasten the blades end-to-end for balancing)

Not necessary, but good to have:
Tacho (more for CP than FP)
Temp Monitor (check your motors temp after long flights)
Volt Meter (to troubleshoot any motor or batt problems)
(if your running Lipos) Balancer

[thorny196]

I went to Lowe's and got it all and I was looking for a good tool box but haven't seen anything I like yet, any suggestions..

Stay Safe
Mike

[RotaryBoy]

I went to Lowe's and got it all and I was looking for a good tool box but haven't seen anything I like yet, any suggestions..

Stay Safe
Mike

Mike,

I roll with this one:

http://www.antonline.com/p_Stack-On-Products--GMB-26RP--TOOL-BOX-26IN-BLACK-POLY-_341562.htm

The two compartments on top are perfect for all my heli parts....
I keep my canopies, batts, and chargers in the bottom under the tool tray...

It's a super tuff box, nice and thick plastic.