problems with lipo and regulator (please help)

[robbin wilham]

i have a titan 50 se and my old jr receiver pack went bad so i decided to go with the spektrum 7.4 2000mah lipo ,spektrum vr6010 regulator .when i read the instructions it says if using any receiver other than ar9100, an optional ec3-to-dual servo lead adaptor is available. then plug the ec3 adaptor into the regulators output and then plug the two servo leads into the battery port and any open auxilary port in the receiver. im using the ar7000,can anyone give me a diagram on the wiring and why does it say to use two plugs to the receiver ,and do i use the on/off switch that i already have on my rappy.if anyone has had this problem i would greatly appreciate any input cause ive had no experience with lipo or regulators,thanks

[Pinecone]

Connect the red wire to the center pin on the servo connector and the black wire to the pin on the side of the connector, the same side as the brown or black wire on the servos.

The reason for two servo plugs is that the servo pins are only good to about 3 amps, so putting 8 - 10 amps through them will burn them up.

[robbin wilham]

thanks so the single end of the y adapter goes to regulator and the other ends go to empty auxilary on receiver and the other goes to batt on receiver. Thanks