Anyone runing a spartan/ got any settings advice

[noste500]

As above,
My tail seems slow on the piro rate and I will speed it up using rudder atv, I am running the ds 760 and the piro stops are a tad slow, allthough I am not fully dialed in yet.
Does anyone have any spartan settings info? What you guys running on the ds760's?

Cheers

[torkboy]

Have you changed anything in the computer?

The only thing I did was took down the decelleration by 4 or 5 bars(there is a triangle on top of the bars , I move the slider down 4 bars), and set my servo type. Setting the decelleration lower makes the tail gears life a little bit easier ;) I do it on all my torque tube equipped helis, always done it. Dont know why your not getting a crisp stop, possibly a low gain issue?

Im seeing a gain of around 35%, and a good starting value is 40%.

[noste500]

Thanks,
I will have a look at the gain, also the deceleration.
What motor are you running?
Cheers

[Finless]

Jason runs a YS 91 SR.

Bob

[CatchmyCorsair]

The deceleration option is only available through the USB, correct? Just another thing to buy. :roll:

[Finless]

Yep... need the cable.

Bob

[noste500]

I have the cable, I will have a play.
Cheers

[noste500]

Have you guys increase the rudder atv to speed up the piros? Mine seem a bit slow.

[torkboy]

Yes increasing the rudder ATVs will speed up the piro.

[ledfoot]

If your engine is on the rich side, it will also affect your piro rate.

[Caleb Phillips]

In the USB menu, take the expo to 0 and the tail sensitivity to 120. With 100% on the Tx endpoints, the tail on my Stratus feels perrrrrfect.

Not sure why you're getting slow stops though. I have my decel three notches down and it still feels a bit to harsh. I'm not too worried about it though.