Hitec or Airtronic servos in Stratus

[jenkij47]

Does anyone know if Hitec HS-5925MG or Airtronic 94758 servos will work with the servo bridge system on the Stratus kits.

Or post which servos you are using for CCPM, not rudder or throttle servos.

Thanks,

Jim

[DavidH]

Futaba 9252's.

Not sure if the servo supports will work with Hitec and Airtronics. But they should as long as the output shaft of the servo is in the same place as Futaba and JR servos.
Don't know if the pivot studs would screw into the Hitec Metal geared servo.
The pivot studs come in 3mm and 2.5 mm threads.

The MA eCCPM helis were originally designed around Futaba servos.

Not using the servo supports is another option also. I flew an Extreme for over 2 years with no servo supports. I know a few more of the MA team pilots that did not use them also.

David

[freddyferris]

I'm using KoPropos! the EVIL setup ^^ KoPropo 2123FET
that are FET servos using a 7,2V power suply (lithium or 5cells NIXX)!

at 7,2V, you get 60° in 0,06sec at 9,5kg power!!!!!

Fully metal Gears + BB ! GREAT servos and F...ing FAST!!!

You plug it just as usual in your RX and the extra cable, you solder it to the + pole of your pack!

They cost about 110$ piece (+ you need extra horns, i think the JR fits kopropo, i got othe ones)

here is a foto:

http://ercmarket.com/eshop/product_image.php?imageid=3987

BUT: you cant use the suport bridge, kopropo use bigger screws than normal servos..

Fred

[megotroulette]

hi jim, i am currently using Hitec 6965 karbonite gear servos, they are fine in the stratus... the only thing is u just re thread the spline with the thingo that replaces the servo screw..

hope this helps,
cheers,

[jenkij47]

Thanks for the input. I think I will go with the 94758's.