What glue to use for clutch liner ???

[virtual120]

What glue should I use for the clutch liner, Epoxy or will Super Glue work ?

Thanks.

[WayneBrown]

epoxy or JB weld. Whichever is handy.
Superglue will not last.

[vandelescrow]

Do not use JB weld as in the last post. If you ever have to replace it you will have to buy a new clutch bell.

Use CA glue.

[LAMAR COOLEY]

virtual120,
Here's my two ents.
CA will not holed up to heat, Although some " may" have had success.
The CA will not bond with metal properly.
I would not recommend it.
Use 30 or 45 min. epoxy. Applying a thin coat to the entire liner.
Trial fit the liner before glueing to establish some roundness to it and checking for a tight fit.
Also wrap one layer of electrical tape around your clutch and insert the clutch into the bell and new liner until the epoxy has set. This will establish a proper clearance for the clutch.
Use rubbing alcohol (70%) for cleanup.
I hope this is of some small help.
Regards

[WayneBrown]

Do not use JB weld as in the last post. If you ever have to replace it you will have to buy a new clutch bell.

Use CA glue.
JB weld is soluable in Acetone, Laquer thinner, and Methyl Ethyl Ketone (MEK)
No reason to have to throw one away.
CA need a porous surface and moisture to bond.

[virtual120]

Great, thanks for th replies. Ill go with the Epoxy then and the one layer of tape. I used two layers of tape last time and the clutch was slipping.

[BarracudaHockey]

Do not use JB weld as in the last post. If you ever have to replace it you will have to buy a new clutch bell.

Use CA glue.

JBWeld works just dandy

[vandelescrow]

JB weld is soluable in Acetone, Laquer thinner, and Methyl Ethyl Ketone (MEK)
No reason to have to throw one away.
CA need a porous surface and moisture to bond.

I stand corrected.

Thanks for posting what will loosen JB weld. I have some carbon fiber boom suports (damaged in a crash) Id like to get new rod and reuse the ends because I can't find anyone who carries that color.