DX7 to X9303

[zeenon]

I need another radio. A friend is learning to fly, so I figure now is a good time to switch and give him the DX7, and I like that the X9303 has a training switch. So my question is how hard is it to transfer all my settings to a X9303? Between helis/combat wings I have about 10 models stored.

Z

[Pinecone]

YOu can copy over most of the settings. The subtrim steps on the X9303 are half the size of the DX7 subtrim steps, so any subtrim should be doubled.

But then, of course, check all the settings and setups before flying.

[marchambault]

I ended up redoing all the setups, using the DX7 as a baseline, but sub-trims and cyclic didn't work out exactly... it seemed like the x9 was faster to setup than the DX7, maybe the menus are better organised?