Help on Motor Connector

[kianhon]

I bought a new ESC for my stock Belt-CP. I need some new connector that allow me to solder it to my new ESC and plug it into the stock Belt-CP motor. What kind of length, diameter and inside hole in mm I should get. To make it easier, which and where I can get one that fits the stock Belt-CP motor?

[copterboy]

My first answer post!!!
:happyd
I think the e-sky ESC/motor connectors are either 2.0mm or 3.5mm gold connectors...I had to do similar work on a new ESC - so haven't got the stock one's to get my calipers out on!

I put 5mm male connectors on the motor wires, and female conectors on the wires from the ESC (this setup avoids the risk of a short circuit if the motor is disconnected for setup work).

I have to admit the 5mm connectors do the job, but they are on the large side.

I wouldn't go above 4mm bullets or else the heat shrink won't shrink to the stock motor wires. If you want stock esky connectors, try http://www.rcmods.co.uk/plugsconnectorswire-c73.html.

Good luck!!