newhelliguy
07-08-2008, 02:35 PM
Since I am a disabled dentist from brain cancer I have more time than money. So I had two blade 400s and a trex 600 and one gy401 gyro. I thought I would make the gyro moveable between the three hellis. This is what I came up with:
Deans 6 prong connectors ---Remove the third prong
These pictures show how I did it. I can move it from one heli to the other in less than 30 seconds.
you will have to enlarge the wiring diagram.
I velcroed the gyro on and ran velcro straps over it and it is very secure.
I was able to leave the end points the same on all three helis and will be running futaba s9650 on all three helis
Deans 6 prong connectors ---Remove the third prong
These pictures show how I did it. I can move it from one heli to the other in less than 30 seconds.
you will have to enlarge the wiring diagram.
I velcroed the gyro on and ran velcro straps over it and it is very secure.
I was able to leave the end points the same on all three helis and will be running futaba s9650 on all three helis