Setting up TRAINER with DX7 and X9303

[zeenon]

Folks,

I've tried this for about 2 hours now, and have come to the conclusion that it can't be done.

I have a DX7 that I would like to be the master and a X9303 as a slave. I put the DX7 in trainer mode and set to master (tried p-link also). Attach the cable to the DX7. Then set the X9303 to slave, the screen comes up "Plug in DSC cable and power off". I do this and flipping the L or R rocker on the DX7 yields nothing on the X9303. In fact I never shift control off the DX7 to the X9303 no matter which switch/switches are flipped.

If I switch and make the X9303 the master and the DX7 the slave it works so I know the cable is good.

L or R rocker I'm assuming the top most switches on the DX7?

Any ideas? I'm at a loss....:dontknow

Z

[tgo]

I have it worked with JR9XII....
The rocker switchs refer to the black switch (+/- switch) next to to Spektrum Logo in the front ! not on the top ! And it's not user friendly to use !


Folks,

I've tried this for about 2 hours now, and have come to the conclusion that it can't be done.

I have a DX7 that I would like to be the master and a X9303 as a slave. I put the DX7 in trainer mode and set to master (tried p-link also). Attach the cable to the DX7. Then set the X9303 to slave, the screen comes up "Plug in DSC cable and power off". I do this and flipping the L or R rocker on the DX7 yields nothing on the X9303. In fact I never shift control off the DX7 to the X9303 no matter which switch/switches are flipped.

If I switch and make the X9303 the master and the DX7 the slave it works so I know the cable is good.

L or R rocker I'm assuming the top most switches on the DX7?

Any ideas? I'm at a loss....:dontknow

Z

[zeenon]

tgo,

That was it, I would have never thought that those switches would be the trainer switches because they are in such an odd place!

Z