Trex 450 SE V2

[divepilot]

I have just installed Trex 450 on Real Flight 4. Works great. I can't seem to get the new heli in the training mode. Each time I go to training another heli is there. I can't find anything in training that will allow this switch.

[phrank]

There is a thread on the Knife Edge forums with a discussion on changing the training heli if you have G4.
http://www.knifeedge.com/forums/showthread.php?t=20812

Briefly however, it involves typing "loadaircraft [modelname]" from the command console.

[divepilot]

I can't find it. Do you mean the keyboard?

[trexflyer02]

Press the "~" key on your keyboard, that will bring up the Console. I believe you should type:

"loadaircraft trex 450se v2"

Something like that ... try it out ...

[divepilot]

OK, I find the console but it tells me it can't find Trex 450 Se V2.
I know it's installed because I have been using it.

[trexflyer02]

The name has to be EXACTLY the same as the correct name of the aircraft.

Load the 450SEV2, then see what it says in the console after. Enter in that exact name.

[divepilot]

Thanks for the help trexflyer. It still dont except it. I have tried every way possible to spell it. It says now that this is not recognized as an internal or external command. Thanks again.

[trexflyer02]

Remember, you still need to type in "loadaircraft" BEFORE the name of the helicopter or plane. If you're getting the internal/external command error, then you're typing loadaircraft wrong or just not typing it at all.

[divepilot]

Thanks trexflyer. All the spaces have to be just right. Now how can I get it to stay? Each time I move from training it goes back to the other heli. Do I need to loadaircraft each time?

[trexflyer02]

Yes, you need to load it every time you want to train with the 450 ... Unfortunately.

Glad you figured it out though! :P