Idle up

[agnar]

How do you put the 9X2 (9303) in idle up on a phoenix???
Gone thru the setup when installing but the chopper doesnt work in idle up,just normal and won´t change with the switch.

[HFG]

Phoenix only reads the signals from your Tx. You have to have an idle up setup in your radio.

[TheBum]

Phoenix only reads the signals from your Tx. You have to have an idle up setup in your radio.
Or you can set up one of the number keys on your keyboard to switch into and out of idle-up. You can do the same thing for throttle hold. That said, it's still better to set up the idle-up and throttle hold curves in the radio if the radio you're using with the sim supports them. The Blade CX2 radio I use is does not allow setting curves, so I use the keyboard.

[agnar]

Ok,found out.Just have to set throttlecurve as in real life on the radio.Thanks for answer anyway.