Telebee Wag Like Crazy

[kianhon]

I installed my Telebee (the one with ATV on it) on my belt-cp and the tail keep wagging left and right violently when I switch onto HH mode. I plugged both wire (multiple color and single color) correctly to the RX. It is installed with on right side of my heli and read from top to bottom. I even try installing it where words reading from left to right (still facing right). It didn't happen when I put back my Esky HH gyro. So what is the problem?

[Real_Sparky]

I think your problem may be that the Telebee is supposed to be mounted where the stock rate gyro goes.
The only gyro I know that is mounted in the side of the heli is the esky hh.

Try it on top of the boom block and see what happens.

What Tx are you using?
If you are using a programmable on try bringing down the gain on the gyro.

Darin

[kianhon]

I'm using the stock Esky Tx. People said telebee should be mounted like Esky HH gyro.

[Real_Sparky]

They may be right about the positioning but what have you got to loose.

If a gyro is wagging it usually means the gain is to high or it is in the wrong spot.
And given that you cant reduce the gain try putting it on top of the boom.


Darin

[cgomega]

Almost sounds like something is reversed, and the Telibee does go on the side like the Esky gyro, I have the one with the ATV on it.

[kianhon]

Can it be mounted on the block where words facing the rear?

[kianhon]

Nvm, I solve the wagging thing. I mounted it on the block where words facing the tail. May be on the side there are too many frequency interferences (I guess) where I have a bunch of wire tied next to it and caused the servo to glitch like hell thus caused the wag.

[DierWolf]

Telebee mounts the same as the Esky HH Gyro, on its end cannot be flat down.

Gain has to be turned alot down on the belt for some reason..