RCE-600

[J-Heli]

I saw this gyro on readyheli while ordering some spares, and was wondering if anyone had any experience with this gyro. It's only 9g so I think that it'd be a good choice for the 'wolverine'. :)

[Jetleaf]

What's up Cuzz? I have this gyro on my Protos with a Hitec 5084 MG and it holds very well. It's just a tad bigger than a Logictech. 26x28x14mm, but yeah it would work on the 200. Here is a video of that setup being tested on a T-Rex 500

http://www.helifreak.com/showthread.php?t=73881

Align is supposed to be coming out with another gyro the G700 that is similar to the Spartan and will only work with digital servos

[J-Heli]

When I saw your wiring job in the Outrage Goodness for the Gaui thread, I became envious (how thick is the servo wire braiding you used on your 200) so I tore down my Gaui and in the process found that the boom was kinked and the tail rotor output shaft was slightly bent, both could explain the vibration issues I had earlier. I also wasn't happy with the cheap chinese gyro I had so I was looking into some fairly inexpensive alternatives. How was the setup process with the RCE-600? I heard about the G700, but I can't wait that long. :)

[Jetleaf]

Setup was just like a 401. The wire braiding is 1/8 inch