BO-105 PAH-1 rotordiameter 3 meter 1:3,2 jet engine jakadofs

[herbert.k]

Greatings from Austria!

The first 4 blades rotorhead in the 3 meter class built in a Bo - 105 PAH-1 1:3.2

Developed from Söllner-Heli and then built by myself.

The fuselage is made of nomex comb to make that really big heilcocpter as easily as possible.

Technical Details:

Rotor diameter : 3 meter Gfk rotorblades
Lenght : 3 meter and 15 cm
High : 1 meter and 5 cm
Weight : 19 Kilo without Kerosin
Gyro : GY 401 Servo 9254
Servos : Hitec Hs-5745 MG Digi
Powerboxsystem : Basic JR
Position flash lights : Beacon Led with Luxeon Emitter
Jet engine : Jakadovsky limited edition
Mechanic : Söllner
Kerosin : 3.5 liters for ten minutes flighttime

I want to sell this helicopter , because i am working on a new project.
This heili is newly and i used him for 25 flights.
I sell him ready to fly with all componentes included.
The dispatch is world wide possible.
The price for this singulary helicopter is 14000 €. / 16600 USD
If you have questions , please contact me.

E-mail adress: herbert.kreuzberger@gmx.at
Take some time and enjoy this videoclip: http://www.pm-video.at/video/video.php

Nice greatings ,Herbert :D :D

[Laurens]

I heard some bad stuff about Martin Soellner. Did you kit went together well?

Also the first rc heli I've seen that sells for more then 10000 euro secondhand.

[Donovan Dow]

I heard some bad stuff about Martin Soellner. Did you kit went together well?

Also the first rc heli I've seen that sells for more then 10000 euro secondhand.

Evening laurens

Care to explain the "bad stuff"

cheers
don dow

[Laurens]

A Dutch customer had to rebuild most stuff because it wasn't aligned properly. Rebuild a swash, frames, etc.

[Tree]

That was a real stupid explantion Laurens. Show some respect and dont be negative in someone's post , unless you have proof when there trying to sell something.

[WillJames]

Please keep in mind Tree that Laurens does not speak English as his native language. He has been involved in flying hobbies a good while and he asked a legitimate question.


For sale ads get a lot more exposure in the for sale section as well. That looks like a KILLER machine!!!

[Tree]

It rwally doesnt matter to me where he's from, he typed in English and to me thats all that matters. And he did not ask a question he made an accusation. There is a difference. If he's been in the hobby that long than he should know that any helicopter that has the gear mesh set wrong will definetly cause problems. I know I wouldnt want someone to put any negative posts in my ad unless there was hard proof.Here I see none.

[Laurens]

Tree, its not just gearmesh.

http://www.modelbouwforum.nl/phpBB2/viewtopic.php?t=22965&start=0

- the hole for the bearings in the main blade grips where off by 2mm.
- pitch compensator didn't work
- swash bearing fell apart
- most pre-assembled bearings were broken
- The exhaust exits where off bij 2.5 cm
- airbubbles in the fuselage
- outer swashbearing diameter = 50mm. It was glued in a hole 50.6 mm.
- bladegrip cracked

This is not a cheap raptor, this heli had cost him 7000 euro. Take a look at the pics.

[Tree]

I stand corrected. :glasses2: