Hatori Pressure Nipple

[Tarawa]

I just recieved my pipe and I noticed theres no pressure nippl hole, so I'm going to assume I need to dril my own, where abouts is the best place the place the hole?

Its going onto an OS 50 Hyper on a Trex 600n, if that info is needed.

Thanks

[DavidH]

Which muffler is it?
If it is like this one
http://www.ronlund.com/Merchant2/merchant.mv?Screen=PROD&Store_Code=heli&Product_Code=HATMSB50HPJK

You take the screw out of body of the muffler. That is where the pressure fitting will go.
Also on some of the two piece mufflers. The pressure fitting screws into the side of the header. I personally have never seen a Hatori that had to be drilled to install a pressure fitting.

David

[Tarawa]

ah, found the screw you mentioned, thank god I didnt get frisky and drill :oops: