Linkage clearance?

[lennydude]

I am in the process of getting a N9 in the air and see that the center (elevator) servo ball end is hitting against the right hand servo ball end as they move.

I would think this is not a normal situation. Is there a secret you guys have to provide the clearance? Was thinking about raising the two outer servos a bit to make it happen but then the linkage will not be 100% straight.

Any help would be awesome :):)

Lenny

[Airboss]

you will only need to raise the R side servo a couple of mm. and you may remove a bit of ballink material to enhance clearance.