odam2k
08-01-2008, 09:48 PM
I bought the Blade 400, so picked up an AR6000 receiver to put in my CP Pro. I got it to bind ok, and followed the instructions found online that deal with the DX6 and CP Pro, but when I power up the 3 in 1, it does the red flashes, then a solid red light. This means throttle is not zero, or Stunt mode is on right? I think perhaps Ive missed something programming the DX6i and the receiver thinks there is throttle input?
The servos work, but no throttle or rudder...
Any suggestions on what to check? I plugged the stock receiver back in and everything is fine....
The servos work, but no throttle or rudder...
Any suggestions on what to check? I plugged the stock receiver back in and everything is fine....