9303 and Revlock

[flyinrazrback]

How can I setup my 9303 and revlock to do this: I want to have control of it on my flight mode switch where N is one speed, and ST-1 and ST-2 are different than N (both ST 1&@ same speed)

[Ivan]

Maybe mix the gyro control channel to its self and set the mix to on in st1 and 2? I.E. If you are using a switched AUX channel, you would mix AUX? > AUX? and set a % based on how much difference you want between the two modes, and in options set the mix to active in st1 and 2. It may take a bit of twiggling, but it should work. This is all spoeaking from the 10X I have, and I am not familiar with the 9303, but I hear it is just as capable as the 10X

I used to mix the throttle channel to its self and make it active only in throttle hold, and use the mix switch to contorl it, so when the mix switch was on and you hit throttle hold, it would kill the engine. This was on my 10X, not familiar withthe 9303, but I reckon a similar scenario would work.

Hopefully someone has a simpler solution. :mrgreen:

[bigrcr]

It is very easy to do using the governor function of the 9303 radio. Take a look see at your radio instructions and the revlock instructions to help figure it out. I don't have the time right now (just briefly answering posts) but I can help you with this if you wish. Send me a PM and as soon as I get the chance (more than likely Fri-Sun time frame) I can give you some help if you have not found it already. Sorry, but TOO busy right now, send me a PM. I can even call you to help you through it.
:arggg:
Later,

[brianbruff]

It's not so hard to do that,
you need to go to device select and set output of gear changel to "GOV", it's possible "ACT" at the moment

Then you will see a new menu Govener in the basic menu.
You set ur ATV rate for Normal 1 and 2 here.

"You set ur ATV rate for Normal 1 and 2 here." what i mean by this is, follow the Procedure specified in ur RevLock manual but don't use the ATV (Leave at 100%) use ur govener menu to fine tune ur speed, set up Pos0 for Mode A, Pos 1 for Mode B,
Then activate Pos0 for Idel Up1 and Pos1 for Idelup2
Hope this helps
brian

it's possible to have Mode A/B activated in normal mode too, maybe with different speeds (specified in the gov menu) it will only arm after 25% throttle