AR7100R and OS SZH pump ?

[shed1980]

AR7100R and OS90 SZH pump.

Is there room for both? I assume yes but have looked at either for a long time.

Failing that, what other "normal" sensors work with the 7100R. (multi gov

Can those who use the 7100R post there underside picures inthe aurora wirring thread?

I find on the heli's that I have the carbsmart mounted the sensor wirring cops alot of abuse.
So I am looking for some better ideas.

[Finless]

See this post here in my Aurora build video post for mounting with a pump

http://www.helifreak.com/showpost.php?p=710267&postcount=198

[shed1980]

Can not believe I missed it.

Any way, I sat down last night. (my new SZH has been packed away for about 18months)

It will work quite easily with the methods described in your thread.

At this stage I will probably trim the pump mounts rather then the sensor.
I may also put a plug close to the pump so the smart carb can be disconnected a litle bit easier.

[noste500]

I did not trim anything to get the sensor to fit, However I did fit it under the pump bracket, ( rather than on top of the pump bracket ), then I put a shim/ washer the other 2 fixings for the pump.
This seemed to work for me.
I did lengthen the pipe to the backplate by a couple of mm to be sure the pump line was not stretched to far.
Not saying this is the correct way, just that it worked for me.
Cheers

[shed1980]

Sounds good.

I actually fitted mine last night.
I dremelled a small ammount off the cabon fibre close to the pump.
Now fits easy.

The only prob is that it's a bit hard to see your clearance.

Looks really neat, and most importantly should be easy to remove when dropping the motor.

[fsusmithc2]

I did not trim anything to get the sensor to fit, However I did fit it under the pump bracket, ( rather than on top of the pump bracket ), then I put a shim/ washer the other 2 fixings for the pump.
This seemed to work for me.
I did lengthen the pipe to the backplate by a couple of mm to be sure the pump line was not stretched to far.
Not saying this is the correct way, just that it worked for me.
Cheers

I modded my pump bracket and the sensor bracket and it seemed to fit ok mounted on top of the bracket....until I tested it. Even fully extended, it wouldn't pick up the crank. I mounted it below the bracket and had 4 washers laying around and spaced the other two holes out perfectly. The line to the crank was allready a bit long so it still fit fine.

[shed1980]

Yep , Fully agree.

Under pump is better.

[nwolsink]

I did not trim anything to get the sensor to fit, However I did fit it under the pump bracket, ( rather than on top of the pump bracket ), then I put a shim/ washer the other 2 fixings for the pump.
This seemed to work for me.
I did lengthen the pipe to the backplate by a couple of mm to be sure the pump line was not stretched to far.
Not saying this is the correct way, just that it worked for me.
Cheers

I did it like this as wel, no drilling or grinding required!