Anyone w/ DX7 & AR7100R...I need help!

[HELINHAWAII]

I'm trying to set up the rev limit function w/ 3 different RPM's using the P-MIX 1 function listed in Bob's 600N governor setup.

I've set up my TX with a dummy 700 model to try it out.

I've got the input select set as:
AUX 2 GEAR
GYRO AUX 2

On P-MIX 1, I've got:
GEAR - GEAR
RATE: +125%
0%
SW: F-S12
OFFSET: -100

So far, I'm not seeing the correct movements on the servo monitor in accordance with what's in the video. Can you guys help me get this figured out or post your settings so that I may copy them to my TX? As always...thanks!

[HELINHAWAII]

Ok so I found this...unfortunately, it's the otheRR site...

http://www.runryder.com/helicopter/t441413p1/

Is this how you guys here are getting by? Looks kinda hokey!

[noste500]

That is how i set mine up on my aurora and t700.

There was a vid here on the freak , it was in hebrew i think, ( not being rude, just can't remember )
Although I could not understand the lingo , it was easy to follow the plan.
Great learning how to program mixes !!

Cheers

[HELINHAWAII]

And it works well enough? You just leave your gear ATV's at 100% and 100%?

[noste500]

Works just like a gov if you set higher throttle curves, ( I am not at 100% throttle curves though, just higher than the limiter )

If you check on the monitor on the DX7 you can see where you are setting it at.
Ps I don't use it in normal, only in idle 1 &2

Bob has lots of good tips in the ar7100r set up vids, which I referred too.
Cheers

[noste500]

Sorry, forgot, yes 100 on gear atv's.