Need to make a binding plug for my DX7

[sikorskys76]

My Remote did Not come with a binding plug.Can anyone tell how to make one? Can I just use a jumper from 1 pin to the other pin leaving the center one untouched?

I have a AR9000 Receiver.

[Pinecone]

That's all a bind plug is. Connect the two outer pins on a servo plug.

[sikorskys76]

All I have to do Is disconnect a servo and connect a jumper between the the 2 outer pins on the receiver?

[Crossfade]

Yes

[sikorskys76]

TY

And can I do that on any AR spectrum Rx? just for future reference:)

[Roadrune]

All I have to do Is disconnect a servo and connect a jumper between the the 2 outer pins on the receiver?

No, it has to be the battery-port.

[sikorskys76]

ok, I disconnect the batterie port then were do I plug the batterie?Just in the slot above?

I noticed on the RX that its was Writen Batt/Bind


Thanks

[Roadrune]

ok, I disconnect the batterie port then were do I plug the batterie?Just in the slot above?

I noticed on the RX that its was Writen Batt/Bind


Thanks

Yep, but you need to power the tx anyway, just put the battery in some other port, and you'll be fine.

[sikorskys76]

Thank you very much!