B-ONE
08-14-2008, 02:02 PM
Guys , take a stab at this. I have a slooow left drift during a hover.
1. Tail servo: S9254, 6 arm servo arm. I have tried the 1st and 2nd hole from the end, same result.
2. Will somewhat hold better if I add 3 clicks of right trim on the TX. I was told it should hold with no trim.
3. Software settings too high will make the tail very sensative, almost a wag, but still slooow drift.
4. Pushrod does not bind anywhere.
5. I have added gyro and rc deadband.
Any thoughts?
1. Tail servo: S9254, 6 arm servo arm. I have tried the 1st and 2nd hole from the end, same result.
2. Will somewhat hold better if I add 3 clicks of right trim on the TX. I was told it should hold with no trim.
3. Software settings too high will make the tail very sensative, almost a wag, but still slooow drift.
4. Pushrod does not bind anywhere.
5. I have added gyro and rc deadband.
Any thoughts?