View Full Version : Little Help ref Futaba 9CHP
tampastooge
12-23-2005, 08:23 PM
Hii Gents
Today I was setting up the Auto Rotation for my Raptor 30 on my 9CHP. I set up all the pitch angles and enabled the switch that I would use. The problem I am having is matching up the idle speed on Normal, with the idle speed when enabling the Auto Rotation switch. The engine would shut off. So in the menu where you can adjust the engine idle, no matter if I go positive or negative on the dail, I noticed the throttle was not moving at all. Is there another location I have to go to, to adjust my engine idle for Auto Roatation.
TY
Cookie
tnreefguy
12-23-2005, 08:34 PM
Thats strange. I have the same radio and I adjust my idle speed with numerical percentage on my throttle hold screen. Do you have it inhibited. at the top of the screen there is an idicator that will say if the mix is inh,on or off. If its in inh the mix will not turn on with the switch position. If it is not you can watch it turn from on to off when you flip the switch.
tampastooge
12-23-2005, 10:12 PM
The switch is working, you can see it go from off to on, and in that same screen, is were I try to adjust the percentage, but can not see the trottle move and yes the switch is in the on position and verfied on the screen itself.
ty
Cookie
tnreefguy
12-23-2005, 10:40 PM
Are you running a gov? Did you increase or decrease the setting by alot? Strange to me.
furywife04
12-23-2005, 10:45 PM
Sounds like you are in throttle cut instead of throttle hold. Disable thr-cut and see if that helps
tampastooge
12-24-2005, 06:15 AM
No Governor and I am in throttle hold menu, thx for advise gent, very appreciated for the help.
Cookie
DavidH
12-24-2005, 08:59 AM
Page 88 of the 9C instruction manual seems pretty clear is how to adjust the throttle idle in throttle hold. You might want to glance at that and see if that will help.
PS. Is this radio a 9C or a 9Z WC II? The reason I ask is I saw a post yesterday you was asking about a 9ZWC II?
David
tampastooge
12-24-2005, 05:19 PM
I have both, but the problem I am having is with the 9chp
tampastooge
12-26-2005, 03:36 PM
ty for all the advise, the problem was that the throttle cut was also assigned to the switch for throttle hold.
thanks again gents
Happy New year to all!!!
Cookie
tnreefguy
12-26-2005, 06:00 PM
i forgot with the 9ch that you can assign any switch. with the 9cap the trottle hold and idle up are not assignable.