yellow_grey
08-21-2008, 03:36 AM
Posted the same on RCU futaba support forum... but anyways wondering if any of you guys are experiencing this problem... haven't seen it so far after searching the forums...
With my 14MZ developing Pot problems on the elevator and waiting to be sent in to Futaba service, got my hands on a 12FG recently.
What i cannot seem to figure out is why i cannot make Switch A and Switch D work as Aileron and Elevator Dual Rate. Currently i have switch B and switch C assigned, but its inconvenient as i prefer to have the shorter switches for control surfaces and the longer ones for gear/ flaps like the usual airplane radio setup.
Initially, i thought Switch A and D weren't working, but if i assign it to say the gear channel or airbrakes, i can see from Servo Monitor that these switches are indeed working fine. Is this a software bug? Have any of you guys experienced this?
FYI, mine is a 12FGA, Asian version updated to 1.6 on 35Mhz
With my 14MZ developing Pot problems on the elevator and waiting to be sent in to Futaba service, got my hands on a 12FG recently.
What i cannot seem to figure out is why i cannot make Switch A and Switch D work as Aileron and Elevator Dual Rate. Currently i have switch B and switch C assigned, but its inconvenient as i prefer to have the shorter switches for control surfaces and the longer ones for gear/ flaps like the usual airplane radio setup.
Initially, i thought Switch A and D weren't working, but if i assign it to say the gear channel or airbrakes, i can see from Servo Monitor that these switches are indeed working fine. Is this a software bug? Have any of you guys experienced this?
FYI, mine is a 12FGA, Asian version updated to 1.6 on 35Mhz