PDA

View Full Version : Show me your electronics for Rappy 90


corona007
09-09-2008, 05:12 PM
Would like to pic someone brain LOL. Show me your pic's. I can't seem to use the search very well. Or If someone has a link to existing topic.
Thans, Lou.

USA_1_INK
09-09-2008, 05:58 PM
Here is the setup on my 90se . Just waiting for the Gov. and Arizona Reg , Batt. to get here .

USA_1_INK

corona007
09-09-2008, 06:11 PM
Cool, Where you going to put the regulator?

USA_1_INK
09-09-2008, 06:13 PM
I am going to put the Reg Underneath where the Batt. is at now . then put the Batt. up above on the tray .

USA_1_INK

corona007
09-09-2008, 06:23 PM
I have the arizona too and thats a great spot I think, But I think I might put my battery (lipo) under the frame. between the landing gear. My 611 amp/display Im thinking on upper left side of frame. Gv-1 and 2.4 on servo tray. Gyro on top rear. What do you think?

Maxime30
09-15-2008, 09:40 AM
Here's mine. Way too many wires!

USA_1_INK
10-18-2008, 09:55 AM
I got my Arizona Reg, And 5200 Relion Batt. , and CY ATGv3 Gov . Just have to give them a test flight .

USA_1_INK

reaaz
12-29-2008, 10:03 PM
Here's the electronic guts in my R90..

Futaba PCM receiver
Arizona heli regulator with pin flag switch (6V regulated & 4.8V to gyro)
7.4V 5000mah relion battery
Futaba 611 Gyro with S9256
Aerospire Multi governor
Futaba S9252 (cyclics)
Futaba S9155 MG (collective)

Not a very attractive layout, but the receiver & battery wrapped in foam (with governor on top) with regulator velcroed vertically behind are very secure & still very vibration protected. Note the Gyro amp is on 1/4" of foam tape
Otherwise, I have also put on a G-force 90 tuner head block, Rocketcity links throughout, Push pull elevator & OS 90SZ-H non pumped with Muscle pipe 5

LAMAR COOLEY
12-31-2008, 08:09 AM
corona007,
Check out my gallery. I've got some shots of my raptor electronics.
Regards