amaury48
09-30-2008, 08:16 PM
I just received my DX6i Transmitter and attempted to set up one of my HDX500s with this TX. I am unable to get the throttle down low enough to allow my ESC to arm. As soon as I turn the unit on the ESC goes into alarm as if there is some throttle input, even thought I have the left joystick all the way down. I have the throttle settings as follows:
Travel Adjust = up - 100% dn - 0%
Throttle Trim = 0%
Throttle Sub-Trim = 0%
Throttle Curve Norm = 0% , 25%, 50%, 75% 100%
Throttle Curve Stunt = 60%, 80%, 100%, 80%, 60%
Throttle Hold = neg 10%
The throttle monitor display shows the throttle under:
NORM: moving from half way to full (mid to full right)
STUNT: moving from half way to full right then back to half way (mid -full right-mid)
HOLD: no movement (stays at mid travel)
The throttle monitor never goes to the left of center, even with the subtrim adjusted to -100%.
If I can't get the throttle to go fully off, I am unable to program my ESC. I initially had the same problem with my DX6 radio but I'm able to set the throttle low position travel adjust to a negative percentage which allows me to set up the ESC.
I have 5 different helis running off my DX6, but I cannot get this DX6i working on any of them. According to the throttle monitor the throttle shows about 50% throttle with the left joystick all the way down.
Confused ? Frustrated !!!!
Travel Adjust = up - 100% dn - 0%
Throttle Trim = 0%
Throttle Sub-Trim = 0%
Throttle Curve Norm = 0% , 25%, 50%, 75% 100%
Throttle Curve Stunt = 60%, 80%, 100%, 80%, 60%
Throttle Hold = neg 10%
The throttle monitor display shows the throttle under:
NORM: moving from half way to full (mid to full right)
STUNT: moving from half way to full right then back to half way (mid -full right-mid)
HOLD: no movement (stays at mid travel)
The throttle monitor never goes to the left of center, even with the subtrim adjusted to -100%.
If I can't get the throttle to go fully off, I am unable to program my ESC. I initially had the same problem with my DX6 radio but I'm able to set the throttle low position travel adjust to a negative percentage which allows me to set up the ESC.
I have 5 different helis running off my DX6, but I cannot get this DX6i working on any of them. According to the throttle monitor the throttle shows about 50% throttle with the left joystick all the way down.
Confused ? Frustrated !!!!