Seeker
02-14-2006, 07:46 PM
Hi All...
Building the rappy 50.. page 7 and the main drive gear assembly.
The manual mentions one way clutch grease after about 10 flights.
No grease before the first 10 flights?
Would the grease go where the one way clutch housing meets the autorotation tail drive pulley or where the shaft goes into the housing (or none of the above)?
Can/should I use the tri-flow grease?
I don't have the kit with me... I'm just reading the manual in a hotel room so if this is a dumb question, I'll blame that I'm not looking at the parts.
:?
Thanks!
Building the rappy 50.. page 7 and the main drive gear assembly.
The manual mentions one way clutch grease after about 10 flights.
No grease before the first 10 flights?
Would the grease go where the one way clutch housing meets the autorotation tail drive pulley or where the shaft goes into the housing (or none of the above)?
Can/should I use the tri-flow grease?
I don't have the kit with me... I'm just reading the manual in a hotel room so if this is a dumb question, I'll blame that I'm not looking at the parts.
:?
Thanks!