Will's Blog
Futaba now officially rate servos @ 7.4v
Posted 08-05-2010 at 08:34 AM by WillJames
As reported today by HF Member psilo in THIS POST on HF
Not sure if it has already been posted here, but a Robbe representative at the 3D Masters confirmed that Futaba are now officially rating a lot of the BLS range of cyclic servos for use at direct 2S lipo voltage (7.4V).
Here is the spec sheet he provided.....
http://cms.robbe.com/downloads/Techn...ervos_2010.pdf
Not sure if it has already been posted here, but a Robbe representative at the 3D Masters confirmed that Futaba are now officially rating a lot of the BLS range of cyclic servos for use at direct 2S lipo voltage (7.4V).
Here is the spec sheet he provided.....
http://cms.robbe.com/downloads/Techn...ervos_2010.pdf
Total Comments 0
