Fun, Learning, Friendship and Mutual Respect
START  HERE

DJI Gaui Hyperion Batteries Empire Hobby

Unregistered
Go Back   HeliFreak > Blogs



Old

Heli-Log 6:7:2012

Posted 06-07-2012 at 08:01 AM by rcnut

Yesterday was a great day to fly, winds around 5 mph! I just had to put some flight time on my Rave, however, disaster struck. The first flight was great, motor running smooth and a bit on the rich side. By the end of the flight, it started to lean out a bit. I checked that idle needle (fuel flow) and it had moved just a little or so it would seem. I turned it out an 1/8th and everything [once again] was fine.

At the end of the second flight, during an auto, the motor died slowly,...
rcnut's Avatar
Registered Users
Posted in Uncategorized
Views 547 Comments 0 rcnut is offline
Old

BlHeli Setup 4.0.0.0

Posted 06-06-2012 at 07:57 PM by 4712
Updated 06-11-2012 at 05:04 PM by 4712

The most recent Revision of BlHeli Setup can be found here
Registered Users
Posted in Uncategorized
Views 3185 Comments 2 4712 is offline
Old

Heli-Log 6:5:2012

Posted 06-05-2012 at 10:11 AM by rcnut

I managed to get a couple of flights before our club board meeting yesterday, on my Rave. I am really liking flying right side up backwards, a lot less cleaning to do! My boom and tail has very little oil residue. My Rave is running great…so far. Just need to look into a couple of things…rpm sensor, a small vibration issue, and I would like to transfer the Rave to the DX8 radio. However, the weather is nice again and the desire to run out and put in more flying after work is great! But I have several...
rcnut's Avatar
Registered Users
Posted in Uncategorized
Views 556 Comments 0 rcnut is offline
Old

Heli-Log 6:3:12

Posted 06-03-2012 at 06:55 AM by rcnut
Updated 06-04-2012 at 07:17 AM by rcnut

Yesterday was a blast! The weather was great and a little breezy. I brought the Rave, Compass 6HV, and Protos 500. I finally had the time to workout the motor issues with the YS 3D motor. After several failed attempts, I just couldn't get this motor to run right. It would start and run, rich on spool up, then lean out once in idle 2. Had a couple flame outs! I wound up draining my starter trying to get this motor to run right. So I placed my starter on charge, and while it was charging, I put in...
rcnut's Avatar
Registered Users
Posted in Uncategorized
Views 505 Comments 0 rcnut is offline
Old

Heli-Log 5:31:2012

Posted 05-31-2012 at 08:38 AM by rcnut

Well it finally happened. The carb on my 3D+ came loose on the second flight, and went lean in flight which resulted in ruining the piston! So this time, I’ll order a new piston and ring, buy all new loctite [red and blue], and silicon gasket sealer. I will rebuild it and try it again, and if that doesn’t work…I’ll buy a new motor.

So far the parts ordered for the Thunder Tiger motor comes to $65.99 [piston, ring, connecting rod (just in case)]. I also ordered a piston, ring, and...
rcnut's Avatar
Registered Users
Posted in Uncategorized
Views 532 Comments 0 rcnut is offline


Copyright © 2004-2011 - William James - Helifreak.com