Guys - looks to me like the main section of the boom will require the hole in the end towards the bevel box to be redrilled to position the bevel box further forward in order to set the center where the stock position is located. Is this correct?

Secondly, I have been tinkering with ideas to shorten the mini torque tube without removing the ends from the original tube. Ozlfyer's concept hasn';t yet worked out for me, as I was unable to find the right shaft diameter to fit the ends. I've not yet given up. I have tested the notion of cutting the tube in a location a little away from the middle of it's length so I can experiment with various diameter tubes and ideas. The torque tube measures 5.92mm od x 4.5mm id. Couple of ideas came to light. I know, over thinking, right...? I discovered that the inside diameter of the tube is about perfect for tapping with 10-32 thread. I thought I could perhaps rejoin the tube to length using a long set screw and some red threadlocker. This will allow for some adjustment as well after I make the cut. The length and snug fit of the set screw will remain straight enough to perform properly. I have found some tubing which should fit on the od of the existing tube to hold the assembly straight if needed. I will find out when the materials arrive.

Incidentally, I also thought of joining the shortened section using a 3/16 diameter roll pin, but the tube isn't large enough to fit. I tested it to no avail.

I will do some research tonight for you Rob on the correct arrow size. The one I used only comes in a dozen, but they are made in all different sizes for different poundage bows and sold separately.

Have you been able to get the drive inserts out OK?

I love your pilots they look great.

I have not got an arrow the right size to try it out will go out to the club and see if I can find one but I am pretty sure this is what you need
Aluminium arrow
Easton Jazz 1516
Easton Plantinum 1516

This is what I used ACC 3L18 Aluminium carbon fiber composite

Thank you, Steve.

I was able to remove the drive ends on the first spare TT I purchased. I have another one new in package for the real deal.

I will check with one of my hunter buds at work today to see if eny of them have any of these arrows.

I had a look at postage AUD 10.5 plus 2 for a bag I can make you one and send it to you.

I ordered a brass tube, 6mm ID from McMaster. It's a perfect fit to the existing torque tube od. Made a cut at about the 40% length mark, and fit a piece of the tube over the outside. Never touched the ends.

It's all fitted together and ready to test fly.I shortened the stinger 8mm. I think the bevel box will be a few mm further back, so not sure how it will fit. No more work until I stuff it.

Yeah it sits a few mm further back but still all goes together with no problems. I wondered about that also when I assembled mine

I deleted your multiple posts but cant get completely rid of them maybe you can?

Guess I don't see any mulitiple posts on my end.