START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar |
Unregistered
|
mCP X Brushless Mods Blade Micro CPx Brushless Mods and Conversions |
Topic Review (Newest First) |
04-16-2012 01:50 PM | |
alex7703 |
Are you starting it in IU or Normal mode? Double check your TX binding procedures. |
04-16-2012 01:48 PM | |
dbennettya |
Good connectors, wiring and short connections? Micro Deans, at least 24AWG wire. Solder directly to motor from ESC and Battery directly to ESC then jumper to main board for power. The stock 26AWG wire and connectors are too wimpy for beefed up motors. YMMV, Don |
04-16-2012 03:19 AM | |
Hoghunter7mm | Brand new hype 550s, gear mesh fine |
04-16-2012 03:15 AM | |
Ampdraw |
Lipos? Gear mesh too tight? Amp |
04-16-2012 01:21 AM | |
Hoghunter7mm | I loosened up the blades grips and now it starts to spool up but quits after a few seconds |
04-16-2012 01:13 AM | |
Hoghunter7mm | Solder looks good, motor screws shortened,mesh good |
04-16-2012 01:10 AM | |
Hoghunter7mm |
Flashed xp12a and hp08s stalls on start up? Wazzup? Just got stuff soldered up and test ran motor without blades and it spooled up nicely...then put blades on and not it stutters and stops quickly. If I try to start it a couple more times it still stutters and esc gets hot. WTF???? Any advice would be helpful. Thx |
Posting Rules |