Quote:
Originally Posted by Mr dan
I find this hard to believe untill I see a video of this in actual motion. Your saying connect the white signal wire to power, where does the ESC get a pulse signal from?
|
Heres a video
Im saying connect the white signal wire from the ESC to the main motor + output pin on the MCPx main board, or to the signal line from the MCU on the back of the board~same places you would hook Thesteve up to depending on which type you have.
The V2 has 1Khz outputs to the motors, V1 has 8Khz. 1Khz is close enough to PPM that the Walkera ESC's are able to use it.
Never said anything about connecting signal to power....