Align 3GX gov set up on TX

[jayfrs]

Hi guys i fitted my 3GX on my 700 Nitro that was running an align governor so i plugged the sensor wire into the 3GX, now before on my other set up with my DX7 AUX2 was my gov and Gear was my gyro but as the 3GX AUX2 is gyro and Gear is gov so on my old set up i had these settings in my TX

Prog MIX1. AUX2 - AUX2 SW:F-NR

Prog MIX2. AUX2-AUX2 SW:F-S12

Prog MIX3 AUX2-AUX2 SW:F-S2

so i have three different head speeds


So i thought as the gov is now gear should my prog mix be GEAR-GEAR i tired this and nothing works when i up the percentage it just has the same head speed in every switch position!

could some on please help me on this one as i am doing something very wrong! and share there TX set up for the governor

Many thanks guys!

[coolj1m]

You will still be using the same switch which is on AUX 2 you would have to use the gear switch to activate govoner mode