Co-pilotII + gyro + gov

ronn1234 · 04-17-2010, 03:26 PM

I was going to put the main sensor on the horz stab fin as in the instr. the vertical senser was going to be placed on the tail boom about 2 in. aft of the main gear box on the opisite side of the muffler. The IR senser will be on the frame on the oppisite side of the muffler as well. How will i be able to tell if these locations are not of sufficant distance. How will the co-pilot react?

Thanks again

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-17-2010, 03:26 PM	#11
ronn1234 Registered Users Thread Starter Join Date: May 2008 Location: Cibolo Tx	I was going to put the main sensor on the horz stab fin as in the instr. the vertical senser was going to be placed on the tail boom about 2 in. aft of the main gear box on the opisite side of the muffler. The IR senser will be on the frame on the oppisite side of the muffler as well. How will i be able to tell if these locations are not of sufficant distance. How will the co-pilot react? Thanks again