Anyone bound a SR Tx to a CP Pro Heli (swapped rx obviously)

MKEGuy · 09-13-2011, 10:45 PM

The CPP with the SR remote is exactly what I am doing!

Except I'm a newb to the air world of helis (lots of experience on the ground though) so this has all been a big learning experience!

I finally met up with my buddy and got the rx from him. I am currently going through the wiring, got it bound, and am working out all of the controls to make sure it works as expected. I still have not connected the motor and spun her up, but the battery is on the charger and that will be next on the check list so I can check tracking and such. I also have to bust out the soldering iron and solder the tail motor up because I put a new one on while I was at it. (new main motor too, I had both items there NIP so I figured what the heck!)

I can't wait to get this thing sorted out and in the air! Seems like this should be a lot of fun!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

09-13-2011, 10:45 PM	#11
MKEGuy Registered Users Thread Starter Join Date: Aug 2011 Location: United States	The CPP with the SR remote is exactly what I am doing! Except I'm a newb to the air world of helis (lots of experience on the ground though) so this has all been a big learning experience! I finally met up with my buddy and got the rx from him. I am currently going through the wiring, got it bound, and am working out all of the controls to make sure it works as expected. I still have not connected the motor and spun her up, but the battery is on the charger and that will be next on the check list so I can check tracking and such. I also have to bust out the soldering iron and solder the tail motor up because I put a new one on while I was at it. (new main motor too, I had both items there NIP so I figured what the heck!) I can't wait to get this thing sorted out and in the air! Seems like this should be a lot of fun!