Fun, Learning, Friendship and Mutual Respect
START  HERE


Unregistered
Go Back   HeliFreak > R/C Electronics Support > Futaba Radios and Electronics > 2.4G Futaba Radios


2.4G Futaba Radios Futaba 2.4G Radio Help and support forum


Reply
 
Thread Tools Display Modes
Old 09-22-2011, 11:46 PM   #1
olemil
Registered Users
 
Posts: 1,702
 

Join Date: Jan 2011
Location: Michigan
Default Another 8FG newbie question

I finally got started transplanting my first Futaba rx in one of my birds and I am a bit confused. I started out like usual setting my servo arms at 90*. One I couldn't get quite there so I used the swash menu (pg6) and neutral position to sub-trim it the rest of the way. So now when in neutral the arms are at 90 and also when at mid-stick, nice. But when I go into the servo menu and select neutral, the arms go back to where I started from in the begining of my set-up. So I am hoping that in the servo menu when you select neutral it is just that with no sub-trim. Is that correct or do I have a problem? Hope I didn't get too confusing with my explanation, just trying to spell it out as clearly as I can. Also, if things are ok the way it is now, do you use that same pg 6 of the swash menu to level your swash at low and high stick also or do you need to use ATV (end points)? I'm guessing that using the pitch>aIL and pitch >ele mix will do the same thing????? Thanks for any help, much appreciated!!!!!
__________________
Beam E4-(Scorpion HK-2221-6,11T pinion, Phoenix 60, HS65MG cyclics, GY520),120SR, Trex 250SE (stock) MH bottom plate,GY-520,Futaba R6106, MCPx,DX7se,Futaba 8FG Super, DJI Flamewheel F450 w/Naza/GPS, HPI Vorza on Futaba 4PL.

Last edited by olemil; 09-23-2011 at 12:01 PM..
olemil is offline        Reply With Quote
Old 09-24-2011, 01:57 AM   #2
olemil
Registered Users
 
Posts: 1,702
Thread Starter Thread Starter
 

Join Date: Jan 2011
Location: Michigan
Default

Never mind, looks like I figured it out.
__________________
Beam E4-(Scorpion HK-2221-6,11T pinion, Phoenix 60, HS65MG cyclics, GY520),120SR, Trex 250SE (stock) MH bottom plate,GY-520,Futaba R6106, MCPx,DX7se,Futaba 8FG Super, DJI Flamewheel F450 w/Naza/GPS, HPI Vorza on Futaba 4PL.
olemil is offline        Reply With Quote
Reply




Unregistered
Go Back   HeliFreak > R/C Electronics Support > Futaba Radios and Electronics > 2.4G Futaba Radios


2.4G Futaba Radios Futaba 2.4G Radio Help and support forum

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


Copyright © 2004-2011 - William James - Helifreak.com