TDR Technical Stuff (Tips) & Build Videos - Page 11

aussiemick · 11-01-2011, 01:06 AM

Quote:

Originally Posted by okteister1

They are for pinning the blades for inverted auto rotations.

That's true for the holes in the grips, but the grip arms are the ones in question here.

I reckon the holes are for setup, getting zero pitch using a rod through the holes.

Mick

okteister1 · 11-01-2011, 03:56 AM

Sorry didnt look close enough at the picture - I was meaning for the holes in blade grips.

Heli G · 11-08-2011, 05:43 AM

Quote:

Originally Posted by zmooth

I was assembling a new kit and I noticed these holes

no clue what they're for, anyone knows or can guestimate ?

I spoke with Jan and the holes in the blade holder arms are just for manufacturing reasons.

HeliBenj · 11-08-2011, 12:46 PM

They're 3mm diameter. Perfect to stick two 3 mm drivers in and check for 0 pitch ! If both drivers are paralel to each other nad to the main shaft you're good to go!

11-08-2011, 12:46 PM	#204
HeliBenj Registered Users Join Date: Jan 2009 Location: Provence, France	They're 3mm diameter. Perfect to stick two 3 mm drivers in and check for 0 pitch ! If both drivers are paralel to each other nad to the main shaft you're good to go! __________________ Ben Goblin 500 IKON w/ gov, Quantum 4115-1200, Hitec 5245, BLS251 DX8, RF6

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-01-2011, 03:56 AM	#202
okteister1 Registered Users Join Date: Apr 2009 Location: Malta	Sorry didnt look close enough at the picture - I was meaning for the holes in blade grips.