binding on antirotation braket

joecass2 · 12-17-2011, 10:23 PM

my elevator link is binding on the antirotation braket. i have the servo balls on all of my cyclic servos set to about 16.5mm. im using Du-Bro servo arms. my question is when looking at the link rods when at center travel thay are all at a angel. can i move only the elevator servo ball out one more spot on the sevo arm this would make the link rod more stright and posably clear the antirotation braket? im using the compass FBL head. i think this would have a big effect on ccpm interaction?

anyone else having this problem?

12-17-2011, 10:23 PM	#1
joecass2 Registered Users Join Date: May 2006 Location: Wayne NJ	binding on antirotation braket my elevator link is binding on the antirotation braket. i have the servo balls on all of my cyclic servos set to about 16.5mm. im using Du-Bro servo arms. my question is when looking at the link rods when at center travel thay are all at a angel. can i move only the elevator servo ball out one more spot on the sevo arm this would make the link rod more stright and posably clear the antirotation braket? im using the compass FBL head. i think this would have a big effect on ccpm interaction? anyone else having this problem?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode