JR 11x model copy on to SD card

[Raydee]

I have owned my 11x for some time now and decided it was finally time to copy all my models on to a SD card. I looked in my manual but I am not seeing anything about formatting the card. What exactly do I have to do?

[Don McCullough]

FOrmat via a PC. Most are already pre-formatted.

[suresharp]

Have you done your up date?

[flyoz]

Its not all that clear.

frst format an SD card in you PC to Standard FAT .
Then insert in to Radio
Then in System mode select Copy/erase.
Then go to top option usually sets at Internal
select model yo copy
Then in lower lst usuallt internal sub heading
Click the heading via the roller switch and it will toggle internal , SD Card, transfer
Pick SD Card
Now ( and this was the bit that through me at first) scroll to the dashed libne wher the model should be placed.
Click here select name ie Heli or acro or Clid then the
Copy command becomes visable on lower left of scree.
Click the corresponding side biutton of the radio
The Radio shows " copying", then "all ok"

The next model is done the same

Not if you accidently clickk the wheel in the above second destination process from SD to Transfer it runs through the inbsert DSC cable etc option and appears to work even though the second radio is not present. This liile glich had me scathcing my head for a couple of hours wondering why the SD card was empty. You must go to SD card the toggle down to the dotted line underneath for mo0del location Doh

[flyoz]

By the way after updateing software and copying modells dont forget to re bind all your aircraft. Dont ask why I know this