Bearings for blade grips ?

[BigRHS]

Hi guys,
I had a vibration when I would spin up and found that i had a bent feathering shaft. So while i was into it, i decided to replace the main shaft, and the flybar. While I was replacing the feathering shaft I accidentally pushed out one of the bearings in the grip. it was the one that is closest to the dampening ring, anyway, it went flying across the floor and down a drain that is in my basement, no getting it back now.
I have done a little search on google but i can't seem to figure out which bearings I need. Does anybody know where i can get a set of these.
I called my LHS and they don't have any.
I am grounded until i can one or a set so any help would be really appreciated !
Thanks.

[BigRHS]

Update,
I think i finally found a set of bearings to replace the lost one in my blade grip.
If someone wouldn't mine to take a look at my link here and tell me if these are the bearings i need.

http://www.ebay.com/itm/280689918262...84.m1497.l2649

Thanks for your help

[ryanjameshay]

The bearing you need is number 23 on the exploded view parts list. Its bearing 3 x 6 x 2.5, EFLH1115. That ebay page is exactly what you need. Check this out too:

http://www.horizonhobby.com/products...ing-2--BLH1115

[BigRHS]

Thanks so much for confirming that for me. I look on HH site but for some reason I must have over looked it.
But i did order the ones on that ebay page so I should get them in a couple of days.
Again thanks !