Jive 80 cooling plate fell off!!!!!!

[J-Money]

In flight my logo 6 shut down I read the blinks there were 8 sent to factory. Upon further inspection the cooling plate that is MOLDED into the esc came off exposing the fetts can I thermal expoxy each fett then snap the plate back into the case or send it back into the factory everything seems to be working just shuts off in idle 2 and hard collective.


Thanks j

[ClubCRASH]

The Jive 80 does not have a molded cooling plate, the cooling plate is a accessory that you glue on. I used CA to glue mine on.

[Blink 182]

Originally Posted by ClubCRASH

The Jive 80 does not have a molded cooling plate, the cooling plate is a accessory that you glue on. I used CA to glue mine on.

Cooling plate is the part your heatsink is glued to, every Jive has one.

[J-Money]

On the "back or front which ever the way you look at it "of the esc there is a sliver plate that you glue an optional heat sink to that plate came out of the esc. Exposing eight square aluminum boxes or fetts. Any help would be appreciated thanks j

[J-Money]

Thanks blink I was trying to clear that up you beat me to it. Lol

[Dumbthumb75]

Originally Posted by J-Money

In flight my logo 6 shut down I read the blinks there were 8 sent to factory. Upon further inspection the cooling plate that is MOLDED into the esc came off exposing the fetts can I thermal expoxy each fett then snap the plate back into the case or send it back into the factory everything seems to be working just shuts off in idle 2 and hard collective.


Thanks j

Here's a thread for you :

http://www.helifreak.com/showthread....+cooling+plate


Hope it helps.

[LARRY2716]

I put thin bead of Shoe Goo between the optional installed Heatsink and the body for better security.

[bloftin]

I've had this happen on a 80HV, I used Thermal adhesive and reinstalled it with a new heatsink on top.

So far it's worked great :-)

This is what I used:

http://www.readyheli.com/C2019-Arcti...e_p_32218.html