MSR Servo

cadetboy2 · 04-30-2012, 01:53 PM

Hi Guys, Has anyone had cause to change a servo on an MSR ?
How difficult is it ? I am a bit concerned about the soldered wire connections. I have a pretty small soldering iron but I am concerned about damaging the control board.
Any ideas or advice ?
Cheers Bob

Pfloyd · 04-30-2012, 06:12 PM

If the motor is good, go this route.

Unscrew the servo.
Carefully pop the motor out of the servo frame
Carefully put the old motor into the new servo frame.
Screw the servo onto the 5n1.
No soldering needed!

cadetboy2 · 05-02-2012, 02:42 PM

Many thanks for that idea. It solves all my problems with soldering.
Cheers Bob

Pfloyd · 05-02-2012, 06:08 PM

No problem!!! I hate soldering too...my 63 year old eyes are not as good as they used to be.

04-30-2012, 01:53 PM	#1
cadetboy2 Registered Users Join Date: Feb 2012 Location: England	MSR Servo Hi Guys, Has anyone had cause to change a servo on an MSR ? How difficult is it ? I am a bit concerned about the soldered wire connections. I have a pretty small soldering iron but I am concerned about damaging the control board. Any ideas or advice ? Cheers Bob

04-30-2012, 06:12 PM	#2
Pfloyd Registered Users My HF Map location Join Date: Mar 2010 Location: Mascoutah, Il USA	If the motor is good, go this route. Unscrew the servo. Carefully pop the motor out of the servo frame Carefully put the old motor into the new servo frame. Screw the servo onto the 5n1. No soldering needed! __________________ MCX/MCX2/MSR/MSRX/MQX/C105B/S300/MCPX/S107G/S107C/S109G/S108/S026/S009G/S023G/S102G/S110G/GYROPTER/ AIRRECON/UDI-803/UDI-816A/SYMAX1/V959/JXD-355/052INTERCEPTOR/EYE1/S113G/UDI-U810/DX7s USAF RETIRED (1968-1988) To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

05-02-2012, 06:08 PM	#4
Pfloyd Registered Users My HF Map location Join Date: Mar 2010 Location: Mascoutah, Il USA	No problem!!! I hate soldering too...my 63 year old eyes are not as good as they used to be. __________________ MCX/MCX2/MSR/MSRX/MQX/C105B/S300/MCPX/S107G/S107C/S109G/S108/S026/S009G/S023G/S102G/S110G/GYROPTER/ AIRRECON/UDI-803/UDI-816A/SYMAX1/V959/JXD-355/052INTERCEPTOR/EYE1/S113G/UDI-U810/DX7s USAF RETIRED (1968-1988) To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-02-2012, 02:42 PM	#3
cadetboy2 Registered Users Thread Starter Join Date: Feb 2012 Location: England	Many thanks for that idea. It solves all my problems with soldering. Cheers Bob